Inverting operational amplifier circuit
the use of an operational amplifier or op-amp in an inverting
amplifier or virtual earth circuit
Operational amplifiers can be used in a wide variety of
circuit configurations. One of the most widely used is the inverting amplifier
configuration. It offers many advantages from being very simple to use,
requiring just the operational amplifier integrated circuit and a few other
components.
Basic circuit
The basic circuit for the inverting operational amplifier circuit is shown
below. It consists of a resistor from the input terminal to the inverting input
of the circuit, and another resistor connected from the output to the inverting
input of the op-amp. The non inverting input is connected to ground.
Basic inverting operational amplifier circuit
In this circuit the non inverting input of the operational
amplifier is connected to ground. As the gain of the operational amplifier
itself is very very high and the output from the amplifier is a matter of a few
volts, this means that the difference between the two input terminals is
exceedingly small and can be ignored. As the non-inverting input of the
operational amplifier is held at ground potential this means that the inverting
input must be virtually at earth potential (i.e. a virtual earth).
As the input to the op-amp draws no current this means that
the current flowing in the resistors R1 and R2 is the same. Using ohms law Vout
/R2 = -Vin/R1. Hence the voltage gain of the circuit Av can be taken as:
Av = R2 / R1
As an example, an amplifier requiring a gain of ten could be
built by making R2 47 k ohms and R1 4.7 k ohms.
Input impedance
It is often necessary to know the input impedance of a circuit. A circuit with a
low input impedance may load the output of the previous circuit and may give
rise to effects such as changing the frequency response if the coupling
capacitors are not large.
It is very simple to determine the input impedance of an
inverting operational amplifier circuit. It is simply the value of the input
resistor R1. This is because the inverting input is at earth potential (i.e. a
virtual earth) and this means that the resistor is connected between the input
and earth.
|
